Progression Continues
 It was a quiet day at G.A.S. so I continued the worx on my future ride.
A friend delivered me a very handy tool to put the body on and I now have the possibility to lay it on its side. Can come out handy during the worx...
 One of the things I did is cut these hole in the rear innerwings to get some airscoops mounted and to get easy excess to the carbs of the little stroker that is planned to take place in the back...
 After cutting the holes, it was time to tackle some welding on the chassis. 
This small section were the frontbeam is mounted was the only place that needed some TLC so I made a couple of patches and welded them in. After some sanding, the repair is almost not visible anymore. Now the only thing that needs to be done to the pan is strip it and get it to the sandblaster and apply some epoxy-based topcoat and it should be good to be build up again.
posted by
Wim
at 9:09 am
Wednesday, October 25, 2006
 
|
.0.jpg)
